500 Mhz Video Input/Output Boards - AMX Optima SD Instruction Manual

500 MHz Video Input/Output Boards

Applicability Notice
This chapter pertains to 500 MHz video input/output boards (with BNC connectors) contained in the
Optima SD systems in the following table:
Signal(s)
RGBHV
RGBHV+Stereo
RGBHV
RGBHV+Stereo
RGBHV
RGBHV+Stereo
RGBHV
RGBHV+Stereo
The first enclosure in each of the Optima SD systems listed above contains three 500 MHz video
input/output (I/O) boards for routing the R, G, and B components of an RGBHV signal.
The second enclosure in each of the systems contains two Hi-Z Sync boards plus a stereo audio board for
systems that include audio.
Signals may only be routed from the inputs on a board to the outputs on the same board because each
board has its own switching matrix.
FIG. 19
500 MHz video input/output boards
Note: For instructions on replacing boards, see "Appendix C – Replacing I/O Boards" on page 67.
Optima SD Instruction Manual
Configuration
16x16
16x16
8x16
8x16
12x12
12x12
16x8
16x8
For information on the Hi-Z Sync boards used to route horizontal and vertical sync signals in
these systems, see the "Hi-Z Sync Input/Output Boards" chapter on page 37.
For information on the stereo audio boards in systems which route stereo audio signals, see the
"Stereo Audio Input/Output Boards" chapter on page 39.
500 MHz Video Input/Output Boards
System Sales #
FGP46-1616-560
FGP46-1616-567
FGP46-0816-560
FGP46-0816-567
FGP46-1212-560
FGP46-1212-567
FGP46-1608-560
FGP46-1608-567
35