SaMASZ K2BF 210 Operator's Manual page 10

b)
K4BF 265 i K4BF 300 (
- because of the fact that the spline shaft has two outputs, the gearbox needs only to be
turned around 180 degrees
Spline shaft with two
outputs
Fig. 7. Adjust the mower K4BF 265, K4BF 300 to work with left PTO direction
End of PTO shaft
with goblet-shaped
cover without clutch.
To be mounted on the
tractor's side.
CAUTION:
The frequency of lubrication of the articulated telescoping shaft should be
carefully adhered to. Points shown in Fig. 8 should be lubricated every
50 hours. The articulated telescoping shaft should also be lubricated before
and after longer periods of disuse.
PTO shafts of other brands with equivalent parameters could be used after SaMASZ permission.
CAUTION:
Before commencing operation, operator's manual on the mower PTO shaft
should be read thoroughly. In the event of the PTO shaft damage due to its use
for any other purpose than specified in the manual, the SaMASZ company
shall not bear any responsibility for the shaft manufacturer not accepting the
warranty
Operator's manual
Fig. 7
):
Fig. 8. PTO shaft lubrication points. Mounting directions
claim.
Front drum mower
K2BF 210; K4BF 265; K4BF 300
- 8 -
End of PTO shaft
with goblet-shaped
cover and clutch.
To be mounted
on mower's side.