Adjusting The Cutting Height - SaMASZ K2BF 210 Operator's Manual

CAUTION:
When replacing knives the tractor's engine should be stopped and ignition
key taken out. The PTO shaft between the mower and the tractor must be
disconnected.
6.2.

Adjusting the cutting height

The mower has a factory-set cutting height of 58 mm. The cutting height can be adjusted by
removing a distance ring (spacer) as show in Fig. 20. After removing a new cutting height of
50 mm is achieved. By putting one additional spacer over the support saucer a cutting height of
66 mm is obtained. Additional spacers are available (optional extras).
a)
Support saucer
Sliding saucer
Distance
b)
ring
Fig. 20. Adjusting the cutting height by: a) removing, b) fitting the distance ring
CAUTION:
When mounting additional distance rings longer bolts - M10x35 must be
used and tightened to a torque of 55 Nm (Fig. 20).
Operator's manual
Fig. 19. Manner of knife mounting on drums:
1 – mounting lever; 2 - knife holder; 3 – knife
Fastening bolts
Front drum mower
K2BF 210; K4BF 265; K4BF 300
- 23 -
Distance
ring
Support
saucer
Sliding
saucer