Preparing The Mower For Work - SaMASZ K2BF 210 Operator's Manual

5.5.

Preparing the mower for work

In order to prepare the mower suspended on the tractor for mowing the following should be
performed:
lower the mower until the sliding saucers come into contact with the ground (Fig. 17),

assemble PTO shaft,

slowly engage the PTO clutch and wait until the cutting unit reaches its rated speed,

engage tractor gear and drive slowly into the grass-field.

Support chain holds up tractor's hydraulic cylinders and maintains mower's level. It causes
lower tear of sliding saucer hub.
CAUTION:
If the mower is improperly adjusted to the ground (Fig. 17), it leads to faster
wear of the sliding saucer hub and knives.
CAUTION:
Mower's nominal rpm: +5 ¸ -10%, i.e. 1000¸ 900 rpm.
Operator's manual
Fig. 16. Instruction of PTO shaft shortening
ADJUSTING THE MOWER FOR MOWING
Incorrect
Fig. 17. Adjust the drums level with the drum
Front drum mower
K2BF 210; K4BF 265; K4BF 300
Correct
- 21 -
Incorrect