Graco Therm-O-Flow 200 Instructions - Parts Manual page 33

NOTE: To ensure accurate hose temperatures, be sure
all heated hoses have their "Zone Type" set to "Hose."
Hoses are only present on odd zone numbers: 1, 3, 5, 7,
or Heat A. If using an expansion module, Heat A-E zone
numbers for hoses are even numbers: 10, 12, 14, or 16.
If a Tandem Therm-O-Flow Warm Melt is used, set
temperatures on the Heat B screens.
NOTE: Connector 5, zone 9, can be configured for a
20L, 60L or 200L Platen. This is set at the factory, but
can be changed as needed.
If using an expansion module, set the primary system
setpoint and setback temperatures for heat zones on
the Heat-A-E screens.
• Select the appropriate "Zone Type" for all installed
zones.
• Check the "A" and "B" boxes according to which
systems need to use the heated accessory.
3A8005A
NOTE: To ensure accurate hose temperatures, be sure
all heated hoses have their "zone type" set to "Hose." If
using an expansion module, Heat-A-E zone numbers for
hoses are even numbers: 10, 12, 14, or 16.
To setup the optional Schedule function, see Schedule,
page 49. The schedule function allows the system to
automatically enable and disable heating and setback at
specified times.
Optional: Set any remaining settings in the Setup
screens before using the system. These are not
required for system operation, but include useful
functions. Other optional heating zone types include:
Hose, Valve, Manifold, PGM, Flow Meter, Press
Regulator, and Other.
Apply a Heat Setting Globally
While still in Heat A or Heat B Setup screen, press the
globalize soft key to apply a setpoint or setback
heat setting across all of the heat zones.
A message will appear prior to completing the change.
Press the soft key to complete applying the
selected parameter. Press the
the globalization.
Setup
soft key to cancel
33