Graco Therm-O-Flow 200 Instructions - Parts Manual page 30

Setup
6. Disconnect the CAN cable from Bulkhead 2 (B2) on
AMZ 1 in the Heat Control Box (S) and reconnect it
to Bulkhead 1 (B1) on AMZ 2 in the Expansion
Module.
AMZ 1
AMZ 2
F . 19
IG
7. Connect the Expansion Module to the Heat Control
Box (S) using the four screws included in the kit.
30
B1
B2
F . 20
IG
8. Install the protective strip around the opening
between the enclosures.
9. Connect the CAN cable included with the Expansion
Module to Bulkhead 2 (B2) in AMZ 1 in the Heat
B1
Control Box (S).
10. Connect the wiring harness (479) from the
Expansion Module to AMZ1 as shown in F
11. Connect the L1, L2, L3, and L4 wires from the
Expansion Module to circuit breaker (445) as shown
in F
IG
B2
. 18.
. 17.
IG
3A8005A