Usb Accessories - RACOM RAy3 User Manual

Configuration

5.4.3.2. USB accessories

The USB connector is used for management access (not for user data) to the local unit using Ethernet
or WiFi adapter. Only RACOM recommended adapters are supported.
Default WiFi IP address of the unit is 172.17.17.17 with DHCP enabled by default allocating IP address
automatically to connected device.
Fig. 5.11: Menu Link settings / Service access / USB accessories
• USB info
Status information about device connected via the USB:
n/a - info not available (HW not known to RAy3 FW = probably not RACOM supplied accessory), or
No device - no device plugged in the USB port, or
List of basic USB module credentials:
○ Vendor ID: Product ID
○ Manufacturer
○ Product
○ WiFi/Eth: up/down — only for network device
○ MAC — only for network device
• IPv4 address
Unit service management address when connecting via USB port.
• Netmask
Network mask when connecting via USB port.
• DHCP start, DHCP end
DHCP range for dynamic address allocation of the management client connected via USB port.
94 RAy3 Microwave Link – © RACOM s.r.o.