Feature Keys - RACOM RAy3 User Manual

5.6.1.2. Feature keys

Fig. 5.40: Menu Tools / Maintenance / Feature keys
The sub-set of RAy parameters is affected by use of Feature keys.
The feature keys limiting data transfer speed [Mbps] and/or few other parameters and functionality of
the RAy unit are available. Speed of the transferred data is determined by a combination of the radio
channel bandwidth (parameter Bandwidth [MHz]) and modulation order (parameter TX modulation).
The Feature key limiting the data transfer speed enables only certain combinations of the channel
bandwidth and modulation order to get the data transfer speed according to the Feature key. The data
transfer speed is typically slightly higher than declared.
When installed, the Feature key is activated after the unit restart. The unit can be restarted using the
Tools – Maintenance – Restart. Choose the Restart mode – warm.
Local
Shows current status of installed Feature keys on Local unit.
• Feature
Name of the function controlled by the Feature key.
Available feature keys:
○ speed
○ Tx power
○ Sync Eth
○ AES encryption etc.
• Limit / Enable
The numeric value set by the key.
• Remove
The specific Feature key can be deleted using the Delete button. The parameters controlled by this
Feature key are reset to their default values after the unit restart. Only Local feature keys could be
deleted. To be able to manipulate the Feature keys, it is necessary to access directly the management
system of the relevant unit - use the IP address of the relevant unit.
© RACOM s.r.o. – RAy3 Microwave Link
Configuration
147