Table of Contents
Advertisement
5-9.
Optical Connector Assembly
Preparation
1.
Remove the top cover. (Refer to
2.
Remove the PS cover. (Refer to
Procedure
1.
Open the clamp 1.
2.
Disconnect the harness from the connector (CN4) on the PS-862 board.
3.
Open the clamp 2.
4.
Disconnect the two optical fiber cables from the AT-191 board.
Optical fiber cables
AT-191 board
Clamp 2
Note
• Do not bend any optical fiber cable to an extent of R = 30 or less.
• Before connecting an optical fiber cable, clean its end.
• When installing, arrange the the optical fiber cable as shown in the figure.
5.
Remove the two screws (PSW3 x 6) to detach the bracket from the rear panel.
6.
Remove the two screws (K3 x 6) to detach the Neutrik fiber cap and the optical connector assembly.
HXCU-FB70
"5-1. Top
Cover")
"5-3. PS
Cover")
CN4
"1"
"2"
PS-862 board
Harness
Clamp 1
5-11
Advertisement
Table of Contents
