Table of Contents
Advertisement
5-7.
Switching Regulator (Small)
Preparation
1.
Remove the top cover. (Refer to
2.
Remove the PS cover. (Refer to
3.
Remove the PS-862 board. (Refer to
Procedure
1.
Remove the four screws to detach the PS bracket.
2.
Remove the insulating sheet PS-B.
3.
Disconnect the two harnesses from the two connectors on the switching regulator (small).
4.
Remove the four screws to detach the switching regulator (small).
PSW3 x 6
PS bracket
Insulating sheet PS-B
PSW3 x 6
Connector
Harness
5.
Install the removed parts by reversing the steps of removal.
HXCU-FB70
"5-1. Top
Cover")
"5-3. PS
Cover")
"5-4. PS-862 Board"
)
PSW3 x 6
Harness
Switching regulator (small)
Connector
5-8
Advertisement
Table of Contents
