Table of Contents
Advertisement
2.
Install the connector plate (LEMO) and the cap by the two screws.
Note
• When installing the connector plate (LEMO), fit the four bosses with the four holes.
Boss
3.
Connect the harness to the connector (CN4) on the PS-862 board.
4.
Close the clamp1.
5.
Connect the two optical fiber cables to the AT-191 board.
6.
Close the clamp2.
Note
• Do not bend any optical fiber cable to an extent of R = 30 or less.
• Before connecting an optical fiber cable, clean its end.
• When installing , arrange the optical fiber cable as shown in the figure.
Optical fiber cables
AT-191 board
HXCU-FB70
Connector plate (LEMO)
Bosses
Holes
CN4
"2"
"1"
PSW3 x 6
Holes
Cap
PS-862 board
Harness
Clamp1
1-12
Advertisement
Table of Contents
