Connection Using Single-Mode Optical Fiber Cable Only - Sony HXCU-FB70 Service Manual

3-1-2.

Connection Using Single-mode Optical Fiber Cable Only

SDI RETURN (HD/SD)
VBS RETURN
PROMPTER
(VBS)
REFERENCE
(HD/SD)
*: The maximum transmission distance is 10 km (32,800 ft) when a general single-mode optical fiber cable with an LC connector is used.
If the unit is connected only with the single-mode optical fiber cable, no power can be supplied from the HXCU-FB70.
Attach the AC adapter AC-DN2B/DN10 to the CA-FB70 or supply power from the CA-FB70's DC IN connector.
Note
• When you use only single-mode optical fiber cable to connect the CA-FB70 to this unit, configure the optical output
setting in the unit. (Refer to the Operating Instructions.)
• Connect the single-mode optical fiber cable as shown below so that connecting destinations cross (A to B, B to A)
between this unit and the CA-FB70.
Single-mode optical fiber
HXCU-FB70
cable (pair)
A
B
• The single-mode optical fiber cable used for the connection must use the cable that the following specifications are
complied with.
- Terminal shaped: PC (Physical Contact) polishing or Advanced PC etc. PC polishing compatible cable
- Wavelength : 1310 nm compliant
HXCU-FB70
RCP-1500 series
REMOTE
SYNC
PIX
COMPONENT (HD/SD)
RGB (HD/SD)
HD SDI/SD SDI
VBS
HDMI
S-VIDEO
CA-FB70
A
B
Single-mode optical fiber
cable (pair) *
Monitor
HXC-D70
3-2