Table of Contents
Advertisement
6.
Set the unit in the rack into the outer rail as far as it will go.
Note
• This rack mounting work must be done by two or more workers so as not to hurt the worker s waist.
• When setting and drawing the mounted unit, be careful not to catch your fingers by the rails.
• If balance is lost when mounting and removing the unit, it may fall, resulting in injury. Mount or remove the
unit carefully maintaining a stable posture.
7.
After the unit has been set in the rack, secure the unit to the rack with four screws (PSW5 x 25).
Note
• Failure to tighten the rack angle screws may cause the unit to slide and fall from the rack, resulting in injury.
After the unit has been mounted, be sure to tighten all the screws.
Inner rail
HXCU-FB70
Rack
PSW5 x 25
Rack angle
Rack angle
PSW5 x 25
1-21
Advertisement
Table of Contents
