Table of Contents
Advertisement
3.
B-Y signal level adjustment
Equipment: SD waveform monitor
Test Point: B-Y connector / rear panel
Adjusting Point: MAINTENANCE menu → M05: COMPONENT LEVEL → PB/B/B-Y BAL TRIM
Specification:
• D = 756 ± 5 mV (NTSC (J), SET UP: OFF) (75 Ω termination)
• D = 700 ± 5 mV (NTSC (UC), SET UP: ON) (75 Ω termination)
• D = 525 ± 5 mV (PAL (CE)) (75 Ω termination)
D
4.
After these adjustments are completed, select "WRITE" to store the setting values.
6-3-5.
Y/Pr/Pb Output Level Adjustment (HD)
Preparation
SYSTEM OPERATION menu setting
Page name
S04: OUTPUT FORMAT
CCU CONFIGURATION menu setting
Page name
C01: COLOR BAR
C09: VIDEO ADJUST
Adjustment
1.
Y signal level adjustment
Equipment: Analog HD waveform monitor
Test Point: Y connector / rear panel
Adjusting Point: MAINTENANCE menu → M05: COMPONENT LEVEL → RGB/YCD TRIM
Specification: A = 700 ± 5 mV (75 Ω termination)
A
HXCU-FB70
Item
COMPONENT
Item
HD BAR
COMPONENT LEVEL
Settings
HD YPbPr
Settings
BAR 16:9 (100%)
0
6-7
Advertisement
Table of Contents
