Table of Contents
Advertisement
Installation
3.8 Setting the flows
Position of the earth bolt.
A=Heat exchanger
B=Earth bolt
After completing the electrical installation, switch on the main switch and all circuit
breakers.
The water flow is set in the factory, but should be checked after the machine has
been installed.
Functions on control panel and circuit board for checking and setting the flow
1.
Display for showing texts
2.
Button for manual operation
3.
Button for the diagnostics function.
4.
Button for switching between diagnostic messages
5.
Circuit board
6.
Plus and minus buttons
WD-59CT & WD-66CT
6
1
2
5
3
4
21
Rev. 2.0 (20110124)
66CT_12
Advertisement
Table of Contents
