Table of Contents
Advertisement
Instructions for use
Alarm texts
Alarm text
(15) WEAK SIGNAL FROM
PHOTOCELL END LIMIT -
CLEAN PHOTOCELL
(47) HACCP ALARM PUMP
FUNCTIONALITY DEFECT -
PRESS RESET
(64) HACCP-LARM FELAKTIG
TEMPERATUR I TANK - TRYCK
RESET
(67) HACCP ALARM WRONG
TEMPERATURE IN BOILER -
PRESS RESET
(72) HACCP ALARM WASHING
DETERGENT FUNCTIONALITY
DEFECT - PRESS RESET
(78) HACCP ALARM FINAL
RINSE DEFECT - PRESS RE-
SET
(26) SENSOR ERROR PULSE
SENSOR B18 - RESTART
FEEDING
(27) SENSOR ERROR PULSE
SENSOR B17 - MAN MODE -
CALL SERVICE
(29) EXTERNAL ALARM INPUT
ACTIVATED
(30) TIMEOUT FILLING OF
TANKS - PRESS RESET
(31) TIMEOUT HEATING
TANKS AND BOILERS - PRESS
RESET
(33) DOOR IS OPEN - CLOSE
DOOR
(40) LOW LEVEL IN TANK 1
(PRE RINSE TANK)
(41) LOW LEVEL IN TANK 2
(CHEM WASH TANK 1)
(45) LOW LEVEL IN FINAL
RINSE TANK
(49) MOTOR PROTECTION
FEEDER ACTIVATED - CALL
SERVICE - RESTART FEED-
ING
WD-59CT & WD-66CT
Cause
There is dirt on one of the photo-
cells (15) at the outfeed.
One of the pumps is not working.
The water level in one of the
tanks is low. The outlet seals
(29, 30) are not closed. The rub-
ber sleeves are not sealing
against the bottom plate.
The washing temperature in one
of the tanks is too low.
The temperature in one of the
booster heaters is too low.
The detergent has run out.
The water stopcock is closed.
The rinse nozzles (19) for the fi-
nal rinse are blocked.
---
---
---
The water stopcocks are closed.
The outlet seals (29, 30) are not
closed. The rubber sleeves are
not sealing against the bottom
plate.
---
---
The outlet seal is not closed. The
outlet seal's rubber sleeve is not
sealing against the bottom plate.
The outlet seal is not closed. The
outlet seal's rubber sleeve is not
sealing against the bottom plate.
The outlet seal is not closed. The
outlet seal's rubber sleeve is not
sealing against the bottom plate.
---
35
Action
Clean the photocells. The alarm in the display
will disappear after cleaning.
Reset the alarm by pressing button (9). Contact
service personnel.
Close the outlet seals. Check the rubber
sleeves. Reset the alarm using button (9).
Reset the alarm by pressing button (9). Contact
service personnel.
Reset the alarm by pressing button (9). Contact
service personnel.
Check and fill with new detergent. Reset the
alarm by pressing button (9).
Open the stopcock. Clean the nozzles. Reset
the alarm by pressing button (9).
Reset the alarm by pressing button (9). Start the
feed by pressing button (5).
The machine can be run in manual mode. Reset
the alarm by pressing button (9). Contact service
personnel.
Reset the alarm by pressing button (9).
Open the stopcocks. Close the outlet seals.
Check the rubber sleeves. Reset the alarm us-
ing button (9).
Reset the alarm by pressing button (9). Contact
service personnel.
Close the door and start the feed by pressing
button (5).
Close the outlet seal. Check the rubber sleeve.
Close the outlet seal. Check the rubber sleeve.
Close the outlet seal. Check the rubber sleeve.
Contact service personnel. Start the feed by
pressing button (5).
Rev. 2.0 (20110124)
Advertisement
Table of Contents
