Table of Contents
Advertisement
Installation
3.6.5 Other assembly
3.6.6 Placement against a wall
•
Fit the overflow pipe (7) between the tanks.
•
Fit the chain (5) to the drive motor.
•
Pull out and connect the electric cables for the pumps and other compo-
nents. The cables are located at the section joint.
•
Each cable is marked with the same designation as the component to
which it must be connected. The marking for each component is on the
component itself and on the machine's stand. The cables are placed in ex-
isting cable runs.
•
The photocells for the infeed are fitted on the adjacent tray conveyor.
If after assembly the machine is to be moved and placed with the back against a
wall, place wooden runners under the stand and push the machine into position
with the aid of a handtruck.
Using a spirit level check that the machine is horizontal and adjust the legs of the
machine if necessary.
WD-59CT & WD-66CT
15
Rev. 2.0 (20110124)
Advertisement
Table of Contents
