Table of Contents
Advertisement
Installation
3.6.2 Assembly of sections
•
Remove any transport supports.
•
Place section 2 in the appropriate place at the right height. Check that the
section is horizontal using a spirit level. Adjust the machine using the legs.
•
Undo the bolts (D) on the stand on section 2 and pull the joining tube (C)
out a few centimetres. Lock the joining tube in this extended position using
the bolts.
D
C
B
Assembling the joining tube.
A=Leg
B=Stand
C=Joining tube
D=M6x10Bolts
•
Place section 1 next to section 2 so that the rectangular metal pieces on
the stands of both sections are in line with each other. Check that section
1 is horizontal using a spirit level. Adjust using the legs.
•
Push section 1 towards section 2 until the joining tube on the stand is
pushed partly into section 1, but do not push the sections completely to-
gether. There should still be a distance between them in order to apply the
silicon around the openings.
•
Apply plenty of silicon around the openings of both sections and around all
bolt holes. Place two strands of silicon along the lower edge.
•
Push the sections together. Hold them together with a screw clamp and fit
the bolts that hold the hoods together. Lock the stand on the front and back
of the machine using two M6x10 bolts. Check that the machine is horizontal
using a spirit level.
WD-59CT & WD-66CT
A
66CT_05
11
Rev. 2.0 (20110124)
Advertisement
Table of Contents
