Table of Contents
Advertisement
Installation
3.6.3 Pipes
Assembly of clamp strips and upper cover plates
•
When the sections have been fitted together, the clamp strips (A) should
be fitted inside the joint. Fit the upper clamp strip first. Apply a small amount
of silicon to the strips before fitting them into place.
•
Seal the joint between the sections on the outside of the machine (back and
top) using silicon. Attach masking tape to both sides of the joint and fill the
joint with silicon.
•
Fit the upper cover plate (3) between the sections.
A
Assembling the clamp strips.
A=Clamp strip
Fit together all pipes for water, steam, condensation water and waste (pipe for
steam and condensation water on steam-heated machines only). The pipes are
split at the section join. The necessary parts for joining the pipes together are fit-
ted to the pipes at the joint. The pipes should be lubricated with a sealant before
joining.
WD-59CT & WD-66CT
A
66CT_08
13
Rev. 2.0 (20110124)
Advertisement
Table of Contents
