Snmp Trap Link-Status (T3 Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide T3 Interface Configuration Command Set
snmp trap link-status
Use the snmp trap link-status command to control the Simple Network Management Protocol (SNMP)
variable ifLinkUpDownTrapEnable (RFC2863) to enable (or disable) the interface to send SNMP traps
when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Value
By default, the ifLinkUpDownTrapEnable OID is enabled for all interfaces except virtual Frame Relay
interfaces.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1 Command was introduced.
Usage Example
The following example disables the link-status trap on the T3 interface:
(config)#interface t3 1/1
(config-t3 1/1)#no snmp trap link-status
61200990L1-35E Copyright © 2005 ADTRAN 629