Ppp Pap Sent-Username/Password (Ppp Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ppp pap sent-username <username> password <password>
Use the ppp pap sent-username/password command to configure a username and password when the
peer requires PAP PPP authentication. Use the no form of this command to remove a configured password.
For more information on PAP and CHAP functionality, refer to the Technology Review section for the
command ppp authentication [chap | pap]
Syntax Description
<username>
<password>
Default Values
By default, there is no defined ppp pap sent-username and password.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 1.1
Usage Examples
The following example specifies a PPP PAP sent-username of local and a password of my_password:
(config)#interface ppp 1
(config-ppp 1)#ppp pap sent-username local password my_password
61200990L1-35E
on page
Specifies a username by alphanumeric string up to 80 characters in length (the
username is case-sensitive).
Specifies a password by alphanumeric string up to 80 characters in length (the
password is case-sensitive).
Command was introduced.
Copyright © 2005 ADTRAN
PPP Interface Configuration Command Set
952.
960