T1 Interface Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
T1 I
NTERFACE
To activate the T1 Interface Configuration mode, enter the interface t1 command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface t1 1/1
(config-t1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through | through <interface id>]
coding [ami | b8zs]
fdl [ansi | att | none]
framing [d4 | esf] on page 607
lbo [long <-22.5, -15, -7.5, 0> | short <0-655>]
loopback commands
remote-alarm [rai]
remote-loopback on page 613
show test-pattern on page 614
snmp trap line-status
snmp trap link-status
snmp trap threshold-reached
tdm-group <group number> timeslots <1-24> speed [56 | 64]
test-pattern [clear | insert | ones | p215 | p220 | p511 | qrss | zeros]
61200990L1-35E
C
ONFIGURATION
on page 31
on page 605
on page 606
begin on page 609
on page 612
on page 615
on page 616
on page 617
Copyright © 2005 ADTRAN

T1 Interface Configuration Command Set

C S
OMMAND ET
on page 604
on page 608
on page 618
on page 619
603