Maximum Paths Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
maximum paths <number>
Use the maximum paths command to set the maximum number of multipath routes to advertise to the
route table via OSPF.
Syntax Description
<number>
Default Values
By default, maximum paths is set to 4.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 11.1
Usage Examples
The following example sets the maximum number of multipath routes OSPF can insert in the route table to
5.
(config)#router ospf
(config-ospf)#maximum paths 5
61200990L1-35E
Specifies the number of routes OSPF can insert into the route table.
Valid range: 1 to 6.
Command was introduced.
Copyright © 2005 ADTRAN
Router (OSPF) Configuration Command Set
1121