Show Processes Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show processes [cpu | cpu realtime | history | queue | stack]
Use the show processes command to display process statistic information.
Syntax Description
cpu
cpu realtime
history
queue
stack
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1
Release 10.1
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
276 ).
Usage Examples
The following is a sample output from the show processes cpu command:
>enable
#show processes cpu
processes cpu
System load: 7.07%
Context switch load: 0.21%
61200990L1-35E
Displays informations about processes that are currently active.
Displays full-screen CPU output in real time. See the Functional Notes below for
more information.
Displays the process switch history.
Displays process queue utilization.
Displays process stack usage.
Command was introduced.
New option was introduced.
Min: 0.00% Max 85.89%
Copyright © 2005 ADTRAN
Enable Mode Command Set
terminal length <text> on page
243