ADTRAN 5000 Series Command Reference Manual page 184

Command Reference Guide
Command History
Release 1.1
Release 6.1
Release 9.1
Release 10.1
Release 11.1
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
276
).
Usage Examples
The following are samples from various show interfaces commands:
>enable
#show interfaces t1 1/1
t1 1/1 is UP
T1 coding is B8ZS framing is ESF
Clock source is line FDL type is ANSI
Line build-out is 0dB
No remote loopbacks No network loopbacks
DS0 Status: 123456789012345678901234
NNNNNNNNNNNNNNNNNNNNNNNN
Line Status: -- No Alarms --
Current Performance Statistics:
0 Errored Seconds 0 Bursty Errored Seconds
0 Severely Errored Seconds 0 Severely Errored Frame Seconds
0 Unavailable Seconds 0 Path Code Violations
0 Line Code Violations 0 Controlled Slip Seconds
0 Line Errored Seconds 0 Degraded Minutes
61200990L1-35E
Command was introduced.
Command was updated to include performance-statistics option.
Command was expanded to include HDLC and tunnel interfaces.
The realtime option and PRI interface were added.
Description, status, and verbose options were introduced. The demand, FXO, and
serial interfaces were added.
Copyright © 2005 ADTRAN
Enable Mode Command Set
terminal length <text> on page
184