Area Default-Cost Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
area <area id> default-cost <value>
Use the area default-cost command to assign a cost of the default summary route sent into a stub area or
not-so-stubby-area (NSSA). Use the no form of this command to delete the assigned cost.
Syntax Description
<area id>
<value>
Default Values
By default the summary route cost is set to 0. There is no default for the area ID.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Usage Examples
The following example defines a default cost of 85 to a specific area:
(config)#router ospf
(config-ospf)#area 192.22.72.0 default-cost 85
61200990L1-35E
Specifies the identifier for this area. Specifies as an integer (range: 0 to
4,294,967,295) or an IP address <A.B.C.D>.
Specifies the default summary route cost. Range: 0 to 166,777,214.
Command was introduced.
Copyright © 2005 ADTRAN
Router (OSPF) Configuration Command Set
1115