Certificate Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
C C
ERTIFICATE
To activate the Certificate Configuration mode, enter the crypto ca certificate chain command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto ca certificate chain MyProfile
(config-cert-chain)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
certificate <serial-number>
certificate ca <serial-number>
crl on page 1042
61200990L1-35E
ONFIGURATION
on page 1040
on page 1041
Copyright © 2005 ADTRAN

Certificate Configuration Command Set

C S
OMMAND ET
1039