Ip Local Policy Route-Map Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip local policy route-map <map-name>
Use this command to specify a route-map for local policy routing on the device. This setting is applied to
the local network interface. Use the no form of this command to return to the default route-map.
Syntax Description
<map-name>
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1
Functional Notes
Before a route map can be specified, it must first be defined using the route-map command. See
route-map <map-name> [ permit | deny ] <sequence number>
Usage Examples
The following example specifies a route-map entitled myMap for local policy routing:
(config)#ip local policy route-map myMap
61200990L1-35E
Specify the name of the route-map.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
on page 439
for more information.
386