Redistribute Static Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
redistribute static [metric <value> | metric-type <type> | subnets]
Use the redistribute static command to advertise routes from one protocol to another. Using the static
keyword allows the advertisement of static routes into the OSPF routing protocol. This will advertise all
static routes on OSPF-enabled interfaces. It does not enable OSPF on all interfaces. Use the no form of this
command to disable the propagation of the specified route type.
Syntax Description
metric <value>
metric-type <type>
subnets
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 1.1
Release 10.1
Functional Notes
Redistributing static routes imports those routes into OSPF without the interfaces in question actually
participating in OSPF. The static routes imported this way are not covered by a network command and
therefore do not send/receive OSPF traffic.
Usage Examples
The following example imports static routes into OSPF:
(config)#router ospf
(config-ospf)#redistribute static
61200990L1-35E
Optional. Specifies a metric value to be carried from one OSPF process to the
next (if no other value is specified).
Optional. Specifies a type 1 or type 2 external route as the external link type. If not
specified, the default is 2.
Optional. Specifies subnet redistribution when redistributing routes into OSPF.
Command was introduced.
Subcommands were added.
Copyright © 2005 ADTRAN
Router (OSPF) Configuration Command Set
1125