Description of the Control Panel (magicolor 5430 DL /5440 DL)
3.2
List of Control Panel Messages
NOTE
• When two or more messages are to be displayed, the message with the higher pri-
ority will be displayed.
• When a message concerning Consumables/Periodic Replacement Parts (Units) is
displayed, print a "CONFIG PAGE" from the "SPECIAL/PRINT CONFIG PAGE"
menu and check the status of the other consumables, too.
☞ "4.2.1 PRINT CONFIG PAGE" 3-13
3.2.1
Normal state messages
• Normal state messages are displayed on the upper line of the LCD.
Message
READY
• Print enabled.
PROCESSING
• Print data processing.
PRINTING
• Data being printed.
WARMING UP
• During warmup.
CALIBRATING
• Color shift correction in progress.
• Machine in Energy Saver mode; returns to normal mode within 35 seconds
ENERGY SAVER
CANCELING JOB
• Job canceled.
3.2.2
Caution messages
• Caution messages are displayed on the lower line of the LCD.
Message
UNSUPPORTED DIMM
TRAY 1 EMPTY
TRAY 2 EMPTY
TRAY 3 EMPTY
FUSER LIFE LOW
TRANS.ROLLER LOW
TRANSFER LOW
FUSER LIFE END
TRANS.ROLLER END
TRANSFER END
WASTE:NEAR FULL
X TONER LOW
SIZE MISMATCH
*: The lower the message in the above list, the higher the priority.
after print data is received.
• DIMM currently installed is not supported.
• No media in Tray 1
• No media in Tray 2 (only when a Lower Feeder Unit is installed)
• No media in Tray 3 (only when a Lower Feeder Unit is installed)
• Fusing Unit needs replacement soon.
• Transfer Roller needs replacement soon.
• Transfer Belt Unit needs replacement soon.
• Fusing Unit service life has been reached.
• Transfer Roller service life has been reached.
• Transfer Belt Unit service life has been reached.
• Waste Toner Bottle needs replacement soon.
• The specified color toner needs replacement soon.
• Media of the size specified in the driver is not loaded in any Tray.
• Media of a size not specified in the driver is loaded in the Tray.
3-6
Main Unit Field Service
Description
Description