Konica Minolta magicolor 5430 DL Service Manual page 63

Firmware Upgrade
4. Check that the "FIRMWARE UPDATE/WAIT" message is displayed.
5. Copy the firmware data and upgrading program to any directory on the PC.
6. Start the Command Prompt and go to the directory in which the firmware data is
stored.
7. Execute the following command to start the transfer of the firmware data to the printer.
(The screen shown below indicates that the firmware data resides on the C drive.)
Data to be upgraded
FW upgraded data
******: File name of FW upgrade data
8. Wait until all of the data is sent. (This takes approximately 2 minutes.)
While the data is being sent, "FIRMWARE UPDATE" and "RECEIVING DATA" are alter-
nately displayed on the screen.
NOTE
• Never turn the printer power switch OFF and ON while data is being sent.
FIRMWARE UPDATE
WAIT
> copy /b 4138**********.prn prn
FIRMWARE UPDATE
RECEIVING DATA
2-26
Main Unit Field Service
4138F2E008DA
Command
4138F2E009DA
4138F2E006DA