Remote Option - JDS Uniphase SWS15100 User Manual

POLARIZER RELAY M A I N
In manual mode, the laser power and wavelength can be set to any value, the laser can be
enabled or disabled, and the four-state polarization controller can be manually controlled. The
procedure for setting the wavelength or power of the laser is similar to that for setting the system
parameters. Press the POWER button to set the power. The following menu, shown in Figure
48, appears. The button marked RELAY is for future expansion. Do not use this option.
Select the value of the parameter and press SET. Press the BACK button to return to the
previous menu. POWER must be enabled to apply the parameter values to the laser.

Remote Option

The REMOTE button on the SOM main menu is used to change the GPIB address of the SOM.
The button is used only if the SOM is being controlled through a GPIB master. It can be used to
set parameters, or execute the SOM, using remote control. When the REMOTE button is
pressed, the display is updated as shown in Figure 49.
62 – Operating and Maintenance Instructions
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure 47: Manual Mode Settings on the SOM
Figure 48: Setting Parameters in Manual Mode