Powering Up The Receiver - JDS Uniphase SWS15100 User Manual

5. Using the 50-pin ribbon fiber cable provided with the new chassis, attach one end to the
(middle) Additional Chassis connector of the last chassis in the set. Attach the other end to
the (top) Computer connector of the new chassis.
6. Attach the AC power cord provided to the new receiver chassis and to the AC power source.
7. Turn the power on for each chassis.

Powering Up the Receiver

To start the receiver, turn the power switch at the back of the chassis to I (on). It is
recommended that the receiver be left on at all times.
The LEDs on the Control Module and Detector Module do not light up when the receiver is
powered on. The LEDs on the receiver will not activate until the software is initialized.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure 15: Setup for Adding a Receiver
Getting Started – 37