Detailed Error Messages - JDS Uniphase SWS15100 User Manual

Detailed Error Messages

The error messages generated by the SWS software are listed in Table 26, with actions to take
when the messages appear.
Error Error Message
Number
2 No such file or directory A file or directory required
12 Not enough memory
28 No space left on device
100 SCPI Command error
300 Device-specific error
310 System error
311 Memory error
360 Communication error
2001 Failed to save
Workspace file
4010 OWB hardware error
4020 No controller detected
4030 No detector detected
4040 OWB timeout
218 – Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 26: SWS Software Error Messages
Possible Cause
by the program was
deleted.
The memory is corrupted.
The disk or device is full.
The device is full.
There is a hardware
problem in the receiver.
The ribbon cable from the
computer to the receiver
is loose.
The ribbon cable from the
computer to the receiver
is loose.
A timeout occurred during
data collection.
Solution
Save the data and files
created. Reinstall the
software.
Reboot the system.
Delete unwanted files or try
a new device (if it is a floppy
diskette).
Free up space.
Check all electrical and
optical connections and try
again. If the error persists,
repair is indicated.
Check the ribbon
connection and try again.
Check the ribbon
connection and try again.
Check all optical
connections. If the problem
persists, measure the
power of the signal going to
the input of the control
module. Check that the
SOM is operating.
(table continued)