Installation; Installing The Transmitter; Source Optics Module; Tunable Laser Source - JDS Uniphase SWS15100 User Manual

Installation

The Swept Wavelength System consists of six main components: a transmitter, a transmitter
cabinet, receiver, application software, and a user-supplied computer with parallel port interface
or data acquisition board. The data acquisition board is an optional component. The tunable laser
source and the source optics module are the two components of the transmitter. This section
outlines instructions for setting up, powering, and testing the system.

Installing the Transmitter

The transmitter, packed in three boxes, consists of:
•

Source optics module

•

Tunable laser source

•

Transmitter cabinet

As outlined below, install the source optics module and tunable laser source in the transmitter
cabinet, which comes fully assembled.
Source Optics Module
The source optics module box contains the following items:
•
SWS15102 or SWS16102 source optics module
•
9-pin RS232 D-sub cable
•
FC/PC 0.3 m jumper
•
AC power cord
•
Certificates of calibration and test reports
•
Packing slip
Tunable Laser Source
The tunable laser source box contains the following items:
•
SWS15101 or SWS16101 tunable laser source
•
FC/APC-FC/PC 2 m polarization-maintaining fiber jumper
•
Mounting hardware
•
Power enable key
•
AC power cord
•
SWS15101 and SWS16101 Tunable Laser Source User's Manual (document SD000319)
Transmitter Cabinet
The transmitter cabinet box contains the following item:
•
OWB10001 transmitter cabinet
The transmitter cabinet is completely assembled.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Getting Started – 25