Testing The Sws Components; Testing The Receiver - JDS Uniphase SWS15100 User Manual

Figure 29. Starting the Wizard from the Start button.

Testing the SWS Components

Testing the Receiver

When the SWS software installation is complete, test the receiver:
1. Start the SWS software. When installed, the program can be run from the Start menu.
2. Verify that the LED on the Control Module displays "CM01".
3. Verify that the LEDs on the Detector Modules display "C001", "C002", and so on. The
channel number corresponds to the location of the detector module in the chassis. The
detector modules nearest the CM are Channel 1 and Channel 2. The upper channel in each
DM is the odd-numbered channel.
If preliminary tests fail, the computer is not communicating properly with the receiver. Test the
parallel port of the computer by connecting the port to a printer or other parallel device, or test the
data acquisition board, if that option is installed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Getting Started – 51