Assembling The Receiver - JDS Uniphase SWS15100 User Manual

•
Control module
•
Detector module
•
Dual Band Selector Switch Module (optional)
The control module and detector module are wrapped in anti-static packaging in the receiver
box, which contains the receiver, cabling, and software:
•
OWB10002 chassis
•
Control module
•
Detector module(s)
•
SWS software on CD-ROM
•
SWS15100 and SWS16100 Swept Wavelength System User's Manual (document
SD000317)
•
Parallel port interface cable
•
50-pin ribbon termination cable
•
50-pin ribbon cable
•
Two FC detector adapters per detector module
•
Two FC/PC-FC/APC hybrid jumpers (1 m and 10 m)
•
Power cord
To install the SWS software using the CD-ROM, see the Installing the Software section.

Assembling the Receiver

The standard SWS system includes one control module and one detector module. More
detector modules are included if more than one is specified when ordering. The control module
and detector modules are installed in the receiver chassis. The first receiver chassis in a series
contains the control module; additional chassis in the series do not require additional control
modules.
Figure 6 and Figure 7 show the receiver setup from the front and back. This configuration shows
three detector modules.
30 – Getting Started
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure 6: Receiver Front Setup