Installing The Dual Band Selector Switch Module (Dbssm) - JDS Uniphase SWS15100 User Manual

OUTPUT TX2
collected over a wider wavelength range. This section explains how to install the DBSSM in the
SWS, and how to use the switch for dual transmitter operation.

Installing the Dual Band Selector Switch Module (DBSSM)

Figure 8 below shows the front panel of the DBSSM.
Figure 8. Front panel of the Dual Band Selector Switch Module (DBSSM)
The DBSSM has two input connectors marked "TX1" and "TX2", and one output connector. All
three are FC/APC connectors. The LED display at the top is used as an indicator, to indicate the
switch number and the transmitter currently selected. An FC/APC-FC/APC connector is
supplied with the DBSSM.
The recommended location for the DBSSM is the last slot, that is to the right of the detector
modules in the last chassis. Tighten the screws at the top and the bottom.
32 – Getting Started
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Caution
The modules are not hot swappable. Turn off the power to the receiver
chassis before installing or removing a module.