Four-State Polarization Controller Rear Panel; Setting Source Optics Module Parameters; Power-Up Screen - JDS Uniphase SWS15100 User Manual

Figure 41: Four-State Polarization Controller Front Panel

Four-State Polarization Controller Rear Panel

The back of the controller is shown in Figure 42.
Figure 42: Four-State Polarization Controller Rear Panel

Setting Source Optics Module Parameters

Before using the SWS system, ensure that the SOM is properly set up to send the correct
signals to the receiver control module. When the SOM is powered up, it initializes the laser and
its own parameters. It also displays the version of firmware installed. After the firmware display, it
automatically displays the main menu, from which the user selects the type of operation
required.

Power-Up Screen

The SOM screen on power-up is shown in Figure 43. The screen is displayed after the SOM has
been properly initialized.
Operating and Maintenance Instructions – 59
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com