Table of Contents
Advertisement
7. Cable Color
Main Power(DC+12V)
BARGATE output (a transistor output) that directly controls a car circuit breaker is used for circuit
1.
breaker control relay operation. The maximum current drain rate is 1 Amps.
HOLD input is used to force NEO RF245 to read a tag when loop sensor detects any approaching
2.
vehicle. When a vehicle is detected, NC contact should be used, and the input should also be
disconnected from GND completely. In OTR mode, the reader will only output tag ID (1 time).
CAUTION: Nothing should be connected to this input unless loop sensor is in use.
OTR cable (yellow) is used to limit the reading time to 1 (OTR = One time reading).
3.
When BOOT_INPUT is connected to GND during firmware upgrade, the system changes into
4.
applicable mode.
CAUTION: Nothing should be connected to this input during normal operation.
Cable name
Power Ground(GND)
Wiegand Data-0
Wiegand Data-1
1)
BARGATE
2)
HOLD Loop INPUT
3)
OTR INPUT
RS232_TX
RS232_RX
4)
BOOT_INPUT
Orange
December. 2016 Copyright IDTECK Co., Ltd.
10
User Manual
Color
Red
Black
Green
White
Gray
Blue
Yellow
Purple
Brown
Hide quick links:
Advertisement
Table of Contents
