Huawei SmartLogger3000 User Manual page 93

SmartLogger3000
User Manual
Figure 6-17 Networking settings
Category
Running Param.
SN List
----End
Issue 03 (2020-01-10)
Parameter
Baud rate
Anti-crosstalk
Network frequency
band
Box-type
transformer No.
Winding No.
Networking
N/A
Copyright © Huawei Technologies Co., Ltd.
Description
Retain the default value 115200 for optimal
communications performance.
Set this parameter to Enable. When the
transformer substation number and winding
number of the solar inverter are the same as
those of the MBUS, or the solar inverter SN is
in the SN list, the solar inverter can connect to
the SmartLogger over an MBUS network.
Set this parameter as required.
Set this parameter based on the number of the
transformer substation connected to the
SmartLogger.
In multi-split transformer substation scenarios,
set this parameter based on the number of the
winding of the transformer station connected
to the SmartLogger.

When the SmartLogger communicates
with the solar inverter over MBUS, set
Networking to Enable.
 When the SmartLogger communicates
with the solar inverter only over RS485,
set Networking to Disable.

Maintain the solar inverter SN list.
 You can click Synchronize to synchronize
the transformer substation number and
winding number of the MBUS to the solar
inverters in the SN list.
6 WebUI Operations
85