Huawei SmartLogger3000 User Manual page 115

SmartLogger3000
User Manual

Parameter
EMI model
Synchronize Environment
Data
Master/Slave

Parameter
EMI model
Synchronize Environment
Data
Master/Slave
Read function code
Data reporting mode
Word ordering
Read mode
Start address
End address
Issue 03 (2020-01-10)
If the model of the connected EMI is displayed in the EMI model drop-down list box,
set parameters as follows.
If the connected EMI is a split EMI that supports Modbus-RTU, set parameters as
follows.
Copyright © Huawei Technologies Co., Ltd.
Description
Set this parameter to the model of the connected EMI.
You are advised to retain the default value Disable.
NOTE
When this parameter is set to Enable, the SmartLogger transmits the
wind speed and direction data to the solar inverter in a PV plant with
the tracking system.
When the SmartLogger connects to multiple EMIs, set one of
them to master mode. The solar inverter performance data
displayed is the data of the EMI in master mode.
Description
Set this parameter to Sensor(ADAM).
You are advised to retain the default value Disable.
NOTE
When this parameter is set to Enable, the SmartLogger transmits the
wind speed and direction data to the solar inverter in a PV plant with
the tracking system.
When the SmartLogger connects to multiple EMIs, set one of
them to master mode. The solar inverter performance data
displayed is the data of the EMI in master mode.
Set this parameter to Read holding register 03H or Read
holding register 04H based on the protocol adopted by the
vendor.
Set this parameter to Integer or Floating point based on the
protocol adopted by the vendor.
Set this parameter to Big endian or Little endian based on
the protocol adopted by the vendor.
The value can be Multiple read or Single read.
If Read mode is set to Multiple read, set the start address for
reading.
If Read mode is set to Multiple read, set the end address for
reading.
6 WebUI Operations
107