Huawei SmartLogger3000 User Manual page 162

SmartLogger3000
User Manual
Figure 8-1 WLAN connection range
Procedure
Step 1 Log in to the app.
1.
2.
3.
4.
Issue 03 (2020-01-10)
(Connecting the SmartLogger to the FusionSolar Hosting Cloud) Open the FusionSolar
app, log in to intl.fusionsolar.huawei.com as installer account, and choose My > Device
commissioning to connect to the WLAN hotspot of the SmartLogger.
(Connecting the SmartLogger to Other Management Systems) Open the SUN2000 app
and connect to the WLAN hotspot of the SmartLogger.
Select installer and enter the login password.
Tap LOG IN and go to the Quick Settings screen or SmartLogger screen
 The screenshots in this document correspond to SUN2000 app and the FusionSolar app local
commissioning tool version 3.2.00.002 (Android).

The initial WLAN hotspot name of the SmartLogger is Logger_SN and the initial password is
Changeme. The SN can be obtained from the SmartLogger label.

The initial passwords of installer and user are both 00000a for the SUN2000 app and FusionSolar
app device commissioning.

Use the initial password upon first power-on and change it immediately after login. To ensure
account security, change the password periodically and keep the new password in mind. Not
changing the initial password may cause password disclosure. A password left unchanged for a long
period of time may be stolen or cracked. If a password is lost, the device cannot be accessed. In
these cases, the user is liable for any loss caused to the PV plant.

If the SmartLogger is powered on for the first time or the factory defaults are restored and parameter
configuration is not performed on the WebUI, the quick settings screen is displayed after you log in
to the app. You can set parameters based on site requirements.
Copyright © Huawei Technologies Co., Ltd.
8 FAQ
154