Checking Direction Of Motor Rotation; Parameter Filter Function - Siemens MICROMASTER 440 Quick Start Manual

Issue 08/03
5.6

Checking Direction of Motor Rotation

WARNING
The following procedures require the motor to rotate. Ensure that the area is safe
around the moving parts before energizing the system. Failure to observe this
precaution could result in severe bodily injury or loss of life.
1. At this point you should "bump" (rotate) your motor if your application allows it.
2. Apply a RUN command and check that the motor is rotating in the correct direction.
If it is rotating in the wrong direction:
a) Swap any 2 of the motor leads over OR
b) Set P0003=2, then set P1820=1 - (this may save some time on a larger unit where it can be
difficult to change the wiring.
5.7

Parameter Filter Function

There are many different parameters that can be found on the MM440 drive giving it a unique
flexibility. In order to make it easier to find the parameters that you are looking for, they can be
arranged according to functionality. P0004 is the parameter that you can use to "filter" or "group" the
parameters according to this functionality.
Table 5.3 below shows these functional groups.
Grouping Parameter
P0004
Setting
ALWAYS 0
INVERTER
2
MOTOR
3
ENCODER 4
TECH_APL 5
COMMANDS 7
TERMINAL 8
SETPOINT 10
FUNC 12
CONTROL 13
COMM 20
ALARMS 21
TECH 22
Table 5-3 Parameter Locations
Please refer to the Parameter List document for further information on these groupings.
52
Description
All parameters
Drive related parameters
Motor parameters
Encoder
Technical applications / units
Control commands, digital I/O
Analog inputs/outputs
Setpoint channel and ramp-function gen.
Drive inverter functions
Motor open-loop/closed-loop control
Communications
Faults, warnings, monitoring functions
PID controller, free blocks
Quick Start Guide
Parameter Ranges
0000 to 3900
0200 to 0299
0300 to 0399 and 0600 to 0699
0400 to 0499
0500 to 0599
0700 to 0749 and 0800 to 0899
0750 to 0799
1000 to 1199
1200 to 1299
1300 to 1799
2000 to 2099
2100 to 2199
2200 to 2399 and 2800 ... 2890
MICROMASTER 440
6SE6400-5GA00-0BP0