Table of Contents
Advertisement
System Wide Data
Setting up a Abbreviated Dialling, Method 2
Example:
Note:
Carrier Presentation Time for Modem
Machine Identifier
20 - Fax Business Controller
This method of programming abbreviated dialling is used after an installation is complete.
All calls will be screened because DK (as outlined previously) is automatically set to 08.
The following example assumes the user abbreviated dialling programming code is ###
(Default).
Step
Dial
1
###
2
NN
3
MM..MM
4
##
5
6
Assuming that by using Method 2, 00 has been assigned the number 441291430000. The
number can be addressed in the following manner:
•
User goes off-hook
•
User dials 00.
The Controller will then dial out 441291430000 (technical support number).
Do not disconnect the power from the Controller, until at least 10 seconds have expired
after exiting programming mode. During this period, any programming in the Controller
is being stored into the Controller's memory. Disconnecting the power prematurely will
result in a loss of programming, and a checksum error (See page 11).
You can specify the time the internal V.21 300 baud modem will present carrier and try
to establish communication before the dialer defaults back to tandem mode programming.
Register
0 for modem disabled
1 for 1 second
2 for 2 seconds
011 T
3 for 3 seconds
4 for 4 seconds
5 for 5 seconds
The Controller may be assigned a unique identification number (ID).
Register
The machine ID must be entered as ASCII Hex and can be
602 XX
up to 40 characters. (5346)
Refer to the ASCII Hex chart in Appendix A, for programming characters.
Description
User abbreviated dialling programming code
Bin location, 00 - 99
Telephone number to be dialled
Enters the information into the controllers memory
Repeat steps 2 - 4 until all numbers are entered
Hang up to exit. Do not dial 999
T =
XX =
'
Issue 1, January 1997
6 for 6 seconds
7 for 7 seconds
8 for 8 seconds
9 for 9 seconds
'
for 10 seconds
8380-377-115-NQ
Advertisement
Table of Contents
