Table of Contents
Advertisement
General Notes on Programming
Programming With a Terminal
PABX
To
Exchange
Line
The user enters programming mode by:
•
The user enters programming mode by:
•
Note:
16 - Fax Business Controller
All local and remote terminal programming will be done with a V.21 300 baud modem.
Programming begins at V.21 300 baud, and if a carrier is not detected from the caller
within the time specified in the 011 Register, the Controller will default back to MF4
mode programming. Refer to Figure A.1 on page 45 for valid controller inputs.
Local Programming
The line side of the modem is connected to the telephone wall plug with a standard RJ11
cable. There must be a PABX/Centrex line port, or simulated PABX/Centrex line port
present on the line-out side of the FBC. The user then has the modem seize the line and
dial #0 , Register 609 default password, which initiates local mode programming. If the
password found in Register 609 matches the password dialed by the modem, the FBC
enters into programming mode. If no modem carrier is detected by the FBC after T
seconds, as specified in Register 011, the FBC will default to MF4 programming mode.
The following screen appears upon entering modem programming mode.
8380 REV 142-XX COPYRIGHT 1991-1996 MITEL INC. ALL RIGHTS RESERVED.
ENTERING PROG. MODE
>
Remote Programming
The user dials the controller and waits for an answer.
Telephone wall plug
Modem Programming Mode
If the FAX machine answers:
matching an entry in Register 606 during
the "quiet time"; waiting for
"CONNECT", and then matching an
entry in Register 604
Tandem Programming Mode
If the FAX machine answers:
matching an entry in Register 606
during the "quiet time"; waiting for
carrier tone to end, and then matching
an entry in Register 603.
For detailed information on how to program the Controller remotely or locally, refer to
the Security Access Registers section in this manual (refer to page 31).
The modem carrier presented by the FBC is very similar to an answer tone presented by
the FAX machine after it has answered an incoming call.
FBC
equipped with Modem
To AC receptacle
If the FBC auto-answers:
The user enters programming mode by:
•
matching an entry in Register 606;
waiting for "CONNECT", and then
matching an entry in Register 604.
If the FBC auto-answers:
The user enters programming mode by:
•
matching an entry in Register 606;
waiting for carrier tone to end, and
then matching an entry in Register 603.
Issue 1, January 1997
PC or Terminal
8380-377-115-NQ
Advertisement
Table of Contents
