Technical Data; Opera)Ng Condi)Ons; Conformity To The Following Standards - Pentair F783E Operating Manual

7.

TECHNICAL DATA

7.1. Opera ng condi ons
DANGER
!
Danger of explosion when used in explosive atmospheres (only in the event of a fault in zone 2)
Opening the control top in an explosive atmosphere is only allowed in a non-energised state
Use only cables and cable glands which have been approved for the respec)ve applica)on area and which have been installed
according to the respec)ve installa)on instruc)ons. Do not expose the device to any mechanical or thermal loads exceeding
that described in the opera)ng instruc)ons
WARNING
!
Risk of injury from overhea ng of the control head.
Ambient temperature:
Standard version:
General hazardous situa ons.
To prevent injuries:
•
Ensure that the system cannot be ac)vated uninten)onally.
•
Installa)on and maintenance work, as well as operator control ac)ons may be carried out by authorised and qualified
technicians only and with the appropriate tools.
•
Do not make any unauthorized internal or external changes to the device!
•
AFer an interrup)on in the electrical or pneuma)c supply, ensure that the process is restarted in a defined or controlled
manner.
•
The device may be installed and operated only when in perfect condi)on and in considera)on of the opera)ng
instruc)ons.
•
The general rules of technology apply to applica)on planning and opera)on of the device.
Degree of protec on:
Standard version:
IP67 according to EN 60529
(only if cables, plugs and sockets have been connected correctly, the cap has been sealed correctly and the adapta)on to the
process valve was done correctly)
7.2.

Conformity to the following standards

•
Certain variants only of the control head F783 EASYMIND 2.0 comply with the EC direc)ves according to the EC
Declara)on of Conformity. The applied standards which are used to demonstrate compliance with the Direc)ves are
listed in the EC Declara)on of Conformity. This may be requested from Pentair Flow TechnologiesPacific Pty. Ltd.
The specifica)ons on the respec)ve ra)ng plate apply to the respec)ve control head. The symbols on the ra)ng
plate indicate the applicable direc)ves or approvals:
Pg 18
0° ... +55 °C (Max. 95% humidity; non-condensing)
F783E / F783E 2.0
00-ISN-191_Rev C
20/01/2018