Safety Instruc)Ons; Electrical Installa)On And Start-Up As-Interface; Bulkhead Connector; Cable Gland With Screw Terminals - Pentair F783E Operating Manual

For installa on in Ex. situa on: refer to special condi ons in Sec on 5 of this manual. Use only Ex. cer fied product
13.4. Safety instruc ons
DANGER
!
Danger of explosion when used in explosive atmospheres (only in the event of a fault in zone 2)
Opening the control top in an explosive atmosphere is only allowed in a non-energised state
Use only cables and cable glands which have been approved for the respec)ve applica)on area and which have been installed
according to the respec)ve installa)on instruc)ons. Do not expose the device to any mechanical or thermal loads exceeding
that described in the opera)ng instruc)ons
WARNING
!
Risk of injury due to electric shock!
•
Before reaching into the system isolate the power supply when it is deemed the power supply could be capable of
causing injury from electric shock!
•
Observe applicable accident preven)on and safety regula)ons for electrical equipment!
Risk of injury from improper installa on!
•
Installa)on should only be carried out by qualified personnel and only with the appropriate tools
Risk of injury, product loss or damage from uninten onal ac va on of the system and uncontrolled opera on of the output!
•
Secure the system against uninten)onal ac)va)on
•
Following installa)on ensure a controlled restart
13.5. Electrical installa on and startup DeviceNET

13.5.1. Bulkhead connector

Generally the DeviceNET control top will be supplied with all internal cabling completed. There will be no need to change
⇒
any por)on of the internal connec)ons in this case. In this case simply connect the bus system to the control head using
the M12 screw-on connector on the bulkhead fiBng.
Fig 21: Electrical connec on DeviceNET bulkhead plug
13.5.2. Cable gland and screw terminals
Connect the cable according to the wiring informa)on in Sec)on 13.3
⇒
Pg 43
F783E / F783E 2.0
00-ISN-191_Rev C
20/01/2018