Electronic Module Led Indicators - Pentair F783E Operating Manual

For installa on in Ex. situa on: refer to special condi ons in Sec on 5 of this manual. Use only Ex. cer fied product

12.5.3. Electronic module LED indicators

Input/ output indicators:
The AS-i module has three large LED indicator on the front. From leF to right:
Red LED indica)ng the Closed switch is ac)vated
Green LED, indica)ng the open switch is ac)vated
Amber LED, indica)ng the Output 0 has been ac)vated
Two smaller indicators are also on the front, each one indica)ng, from leF to right, output 2 and 1 is ac)vated.
System Fault indicator
On the top of the module is the system FID indicator. This is used for system diagnos)cs as below:
Off
System OK, device is
connected and running
System is powered off
Fig 18: Electronic module LED indicators AS-i
Pg 39
Flashing
Device address not 0,
Device at address 0
but not registered in
Device is connected
but power jumpers
F783E / F783E 2.0
On steady
Open switch
Closed switch
indicator
FID indicator
Solenoid 2 energised
Indicator
Solenoid 3 energised
Indicator
Solenoid 1 energised
Indicator
Indicator
00-ISN-191_Rev C
20/01/2018