Cabling A Single-Interconnect Configuration; Hardware Management Network Connectivity - Lenovo ThinkAgile CP Hardware Part Replacement And Component Maintenance Procedures

Cabling a single-interconnect configuration

Procedures for cabling theThinkAgile CP single-interconnect switch configuration.
Complete these procedures to cable a single-interconnect configuration.
Hardware management network connections
Connect the following ports to the management switch:
• Interconnect port 47 using a SFP+ Direct Attach Cable (DAC)
• Compute block port (C.M.) using a RJ45 patch cable
• Upper storage block port (S.U.M.) using a RJ45 patch cable
• Lower storage block port (S.L.M.) using a RJ45 patch cable
Figure 59. Hardware management network connectivity in a single interconnect configuration
Note: If not using the Lenovo ThinkSystem NE0152T RackSwitch as the management switch, you may
require different cables for the management network connections.
134
Lenovo ThinkAgile CP Hardware Part Replacement and Component Maintenance Procedures